EXHAUST PRE-SILENCER, 81-83
Racing Beat Exhaust Pre-Silencer, 71-78, 81-83
The Racing Beat Power Pulse Presilencer for the 1971-78 & 81-83 RX-7 is designed to be used with our wide selection of RX-7 Streetable Headers to complete a bolt-on configuration. These Power Pulse Presilencers are ideal for those individuals wanting to fabricate custom exhaust systems incorporating either long or short primary exhaust systems.
The Power Pulse Presilencer improves the character of the exhaust noise, dramatically reducing the inherent, obnoxious metallic high frequency noise with virtually no power loss. Constructed with a high temperature, 2-inch I.D. perforated core of 304 stainless steel wrapped with high-temperature stainless steel wool, the Power Pulse Presilencer measures 20 inches in length with a 4-inch outside diameter. The mounting studs are 12mm both front and rear.
| SKU: | 16400 |
EXHAUST PRE-SILENCER, 81-83
$291.06
Related Products:
-
-
EXHAUST CONVERTER GASKET, 81-85 MONO + 84-85(REAR)
81-85 Mono Converters Gasket, 84-85 Rear Main Converter Gasket
SKU: 13-621A-1480 Manufacturer SKU: 1480-13-621A -
-
EXHAUST CENTER SECTION, 79-85 RACING BEAT 4 PORT/6 PORT
Racing Beat Exhaust Center Section, 79-85 4 Port/6 Port
SKU: 16398 -
EXHAUST CONVERTER GASKET, 81-85-FRONT 81-83-REAR
81-85 Front Main Converter Gasket
81-83 Rear Main Converter GasketSKU: 40-325A-1480 Manufacturer SKU: 1480-40-325A -
EXHAUST HANGER, 2 SLEEVES
Exhaust Hanger, 2 Sleeves
Go To Our FAQ for Exhaust Hangers to see the locations and part numbers of the hangers for your car.
SKU: 40-1600-1114 Manufacturer SKU: 1114-40-160
You May Also Like:
-
-
EXHAUST HEADER 13B, 74-78 NO FLANGE EXCEPT PICK UP
Racing Beat 13B Exhaust Header, 74-78 No Flange. Will not work on the Pick Up
This rotary exhaust Header/Collector (less outlet flange) is ideal for RX-2, RX-3, RX-4, and COSMO (does not fit rotary pickup) custom exhaust installations. The flame-cut, .5-inch thick engine flange provides positive sealing and alignment. By integrating the collector with the header we reduce the effort and cost in completing the exhaust system. Engine-to-pipe gaskets are not included but are available separately. An Air Control and Check Valve Cover Plate is required when using this header with a stock intake system.
If the stock resonator is eliminated during installation of this unit, we strongly recommend selecting a Power Pulse Presilencer and installing it in place of the resonator to maintain a pleasant noise level and character.
SKU: 16007 -
-
EXHAUST STUD, RENESIS EXHAUST MANIFOLD TO ENGINE
Exhaust Stud Renesis, Exhaust Manifold to Engine (4 Required)
SKU: 13-708A-SL50 Manufacturer SKU: SL50-13-708A -
-
EXHAUST HEADER 13B, 86-88 6 PORT DUAL PIPE
Racing Beat 13B Exhaust Header 86-88 With 6 Port Actuation and O2 Sensor Fitting Dual Pipe
SKU: 16128