Flywheel Hardware 83-92 N/A Mazdatrix Aluminum
Flywheel Hardware 83-92 N/A Mazdatrix Aluminum
This kit is included in the 104806-11 flywheel.
SKU: | 95181 |
Flywheel Hardware 83-92 N/A Mazdatrix Aluminum
$42.47
Related Products:
-
FLYWHEEL REPLACEMENT FRICTION SURFACE FOR MAZDATRIX 225mm ALUMINUM FLYWHEEL
Flywheel Replacement Friction Plate for MAZDATRIX 225mm (9″) Non Turbo flywheel.
This is a replacement friction plate for our 225mm ALUMINUM flywheel for the non-turbo diameter (11 3/4″) flywheel.
New bolts and nuts for installation are included.
Note: The bellhousing and starter determine the diameter of flywheel needed, With all the race / street car transmission combinations out there Turbo versus non-turbo can sometimes be not the best definition – better to measure your flywheel diameter.
SKU: HS9057 Manufacturer SKU: HS9057 -
CLUTCH KIT STAGE 2, 83-92 NON-TURBO
Clutch Kit Stage 2, 83-92 Non-Turbo
Race performanceExedy Stage 2
Race performance, Metal Puck Disc and Upgraded Pressure Plate
Includes Disc, Pressure Plate, T/O Bearing, Pilot Bearing and seal, and Alignment ToolWe open every Exedy Kit to make sure that the correct Pilot Bearing and seal are included, due to Exedy rarely includes the pilot seal and sometimes has the incorrect bearing.
SKU: 10954 Manufacturer SKU: 10954 -
REAR COUNTERWEIGHT 83-85 12A
Rear counterweight for 83-85 12A Engines — they have the “N” on the rotors
These were discontinued by Mazda — We are having them made.
We took a few pair of 83-85 12A rotors, weighed them all for an average, set the bobweights for those weights on a 12A eccentric shaft then we re-balance NEW 13B rear counterweights to match.
SKU: 11-751A-N226-MOD Manufacturer SKU: N226-11-751A-MOD -
NON-TURBO Diameter MAZDATRIX ALUMINUM FLYWHEEL 83-92
83-92 NON-TURBO Diameter MAZDATRIX ALUMINUM FLYWHEEL
Mazdatrix designed aluminum flywheel.
With our flywheel the pressure plate bolts directly to the flywheel and uses the original style locating dowels, eliminating the need for separate spacers.
Comes with all necessary hardware.Flywheel is 11 3/4″ Diameter which fits ALL Non-Turbo Transmissions from ~1974-1991. It uses a 225mm CLUTCH which is standard from ’83 – 1991.
Weight is 7.6 POUNDS with hardware w/o counterweight.
Rear counterweight must be purchased separately to match the engine
Can be used on all 74-82 engines originally equipped with a 215mm clutch, but you must buy a 225mm 83-92 clutch.
Lighter than other ALUMINUM flywheels at 7.6 pounds versus theirs at 8.5 pounds.
SKU: 104806-11 Manufacturer SKU: 104806-11 -
FLYWHEEL STOPPER TOOL, ALL Non-Turbo diameter flywheels
Flywheel Stopper Tool, All Non-Turbo diameter flywheels (Except RX-8’s)
Flywheel stopper makes getting the flywheel / counterweight nut off a LOT easier.
For flywheels 11 3/4″ diameter.SKU: 49-220NT Manufacturer SKU: 49-220NT -