PILOT BEARING INSTALLER TOOL
Pilot Bearing Installer Tool
SKU: | 49-MT-110 |
PILOT BEARING INSTALLER TOOL
$18.86
Related Products:
-
PILOT BEARING REMOVER TOOL
Pilot Bearing Remover Tool
To remove the old pilot bearing the bearing MUST be gripped at its front end. Very few of the aftermarket pullers we tested were able to do this correctly. They often tended to destroy the bearing making removal even harder.
To use the tool simply insert the attachment into the bearing, being sure to get it to the end of the bearing, insert the tapered / threaded end of the slap hammer part and screw them together until the bearing is firmly gripped. Then just “slap hammer” it out. Should take less than a minute.
This tool prevents eccentric shaft damage when removing bearing.
This tool does fit other cars including Miata. We do not have a list of cars that it will work on. The RX pilot bearing/input shaft measures .588″. If your application also has a .588 shaft/bearing, this tool will work.SKU: 49-1285 -
CLUTCH PILOT BEARING, ALL ROTARY 74-11
Clutch Pilot Bearing, All Rotary 74-11
SKU: 11-D030-N326 Manufacturer SKU: N326-11-D03 -
-
ENGINE STAND, HEAD ONLY-ALL ROTARY
Engine Stand, Head Only-All Rotary
Please note: This is for the HEAD only – actual engine stand is not included (nor is the engine).Pipe size is 2 3/8 outside diameter – the most common size. PLEASE be sure your engine stand uses that size!!
SKU: MZTX-ENG-STAND Manufacturer SKU: MZTX-ENG-STAND -
PILOT REMOVER TOOL, END PIECE ONLY
End piece for OUR pilot bearing remover tool.
As far as we know it will not fit any other remover / slap hammer.
Thread is 1/2 x 13
SKU: 49-1285-END -
FLYWHEEL STOPPER TOOL, TURBO, AUTO TRANS AND RX8
Flywheel Stopper Tool, Turbo, Automatic Transmission And RX8 Manual
SKU: 49-220TB Manufacturer SKU: 49-220TB