WEBER INLET SEAL, STAT-O-SEAL FOR 12MM

Related Products:

• 

  WEBER IDLE SPEED SCREW

  Weber Idle Speed Screw
  Spring is not included. It is 47600.007

  Browse our Weber Carbs, Manifolds and Parts section

  SKU:

  64625.012

  $4.80
  Add to cart
• 

  Weber Air Jet – Choose-A-Size

  Weber Air Jet
  All of the sizes we carry are listed here.

  Click Here for a Weber 48IDA Suggested Parts List

  Browse our Weber Carbs, Manifolds and Parts section

  SKU:	77401 Weber Air Jet

  $7.88
  View products
• 

  WEBER IDA IDLE MIXTURE SCREW

  Weber IDA Idle Mixture Screw

  Browse our Weber Carbs, Manifolds and Parts section

  SKU:

  64750.007

  $7.57
  Add to cart
• 

  Weber Main Fuel Jet – Choose-A-Size

  Weber Main Fuel Jet
  All of the sizes we carry are listed here.

  Click Here for a Weber 48IDA Suggested Parts List

  Browse our Weber Carbs, Manifolds and Parts section

  SKU:	73401 Weber Main Jet

  $7.88
  View products
• 

  Weber IDA Chokes

  Weber IDA Chokes
  72128.+Size

  When you choose your choke size below, you will be able to purchase.

  Select your choke size below

  Click Here for a Weber 48IDA Suggested Parts List

  Browse our Weber Carbs, Manifolds and Parts section

  SKU:	72128 IDA Chokes

  $31.04 – $42.03
  View products
• 

  WEBER SHAFT LEVER, WITH STOP PIN LEFT

  Weber Shaft Lever, With Stop Pin Left.

  14ga steel
  We have these “stops” made for us so the throttle STOP is on the same side of the carb as the throttle PULL. Adjusted correctly this prevents the throttle shaft from being bent when full throttle is applied.
  This is our latest design that “includes” the washer that covers the shaft bearing. This also allows more thread engagement of the nut onto the throttle shaft as you no longer use the original bearing cover washer.

  All descriptions refer to a front mounted rotary engine in a rear wheel drive car.

  There are two types of manifold for downdraft IDAs: fuel inlet on engine side with throttle cable pulling from above the throttle shaft, and fuel inlet on the fender side, with the throttle cable pulling from below the throttle shaft. The manifold determines the carb orientation. It is best to have the cable pull, the idle speed screw, throttle stop, and return spring all on the same end of the carb. If this is not done, you will twist the throttle shaft, which can lead to various poor running conditions.

  
  Click Here for a Weber 48IDA Suggested Parts List

  Browse our Weber Carbs, Manifolds and Parts section

  SKU:

  MAT460-L

  $18.88
  Add to cart