INJECTOR PINTLE CAP, 93-95 SECONDARY

INJECTOR PINTLE CAP, 93-95 SECONDARY

Secondary Injector Pintle Cap, 93-95 

SKU: 13-MZTX-0002

INJECTOR PINTLE CAP, 93-95 SECONDARY

These are the small caps on the ends of the injectors — they like to “disappear” while you have the injectors out of the engine. Sold individually.

Note: We have still never found a source for the pintle caps for 93-95 Primary injectors.

 

$2.25

Related Products:

You May Also Like:

  • AIR FILTER HOUSING RACING BEAT HOLLEY W/O FILTER

    AIR FILTER HOUSING, RACING BEAT HOLLEY WITHOUT FILTER

    Racing Beat Air Filter Housing Without Filter for Racing Beat Holley Carburetor

    Racing Beat’s dyno-proven Power Pulse Air Filter Assembly, for the Holley Carburetor, is designed specifically for performance. While the assembly uses the same Racing Beat foam air filter element that fits the stock canister, the design of the Power Pulse canister both improves air flow into the carburetor and limits the introduction of dirt particles into the filter element. The spun aluminum canister pieces are powder-coated white for added durability.

    The Power Pulse Air Filter Assembly fits most Holley 465, 550, 600, and 650 CFM carburetors (specifically, all Racing Beat Holley Intake System Kits). There is no provision for emission control valve hose/air pump hose connections on this assembly; however, there is a position available to connect a crankcase breather tube if needed.

    SKU: 16530
    $109.15
    Add to cart
  • WEBER MANIFOLD for PERIPHERAL PORT 13B 48 or 51IDA RB PERIPHERAL PORT HOUSING

    WEBER MANIFOLD for PERIPHERAL PORT 13B 48 or 51IDA RACING BEAT PERIPHERAL PORT HOUSING

    Weber Manifold for Peripheral Port 13B 48 or 51IDA
    This manifold is designed to fit the Racing Beat Periperal Port 13B Rotor Housings.

    Works with IDA carbs from 48mm to 52mm bore.

    The Racing Beat-designed and manufactured Peripheral Port Intake Manifold mates a Weber 48 IDA or 51 IDA downdraft carburetor, or equivalent throttle body, to the Racing Beat-manufactured 13B peripheral port housings. (This manifold cannot be used on the Mazda Factory Race MFR housings.) The steel tubing manifold is attached to the rotor housings with hoses that are included. A simple support bracket fabricated for your particular application, typically attached from the carburetor-manifold junction to the threaded bosses on top of the rotor housings, will complete the task.

    Browse our Weber Carbs, Manifolds and Parts section

    SKU: 16490
    $363.83
    Add to cart