Seals, and Pilot Bearings
-
CLUTCH PILOT BEARING, ALL ROTARY 74-11
Clutch Pilot Bearing, All Rotary 74-11
SKU: 11-D030-N326 Manufacturer SKU: N326-11-D03 -
CLUTCH PILOT SEAL, ALL ROTARY 74-ON
Clutch Pilot Seal, All Rotary 74-On
SKU: 11-404A-1881 Manufacturer SKU: 1881-11-404A -
FRONT MAIN OIL SEAL, 93-95 RX7, 04-11 RX8
Front Main Oil Seal, 93-95 RX7, 04-11 RX8
SKU: 10-5070-N3R1 Manufacturer SKU: N3R1-10-507 -
FRONT MAIN OIL SEAL, ALL THRU 92
Front Main Oil Seal, All Through 92
SKU: 10-6050-0820 Manufacturer SKU: 0820-10-605 -
O-RING DOWEL PIN, ALL ROTARY
Dowel Pin, O-Ring All Rotary
SKU: 10-B730-N3A1 Manufacturer SKU: N3A1-10-B73 -
OIL LEVEL SENSOR SEAL O-RING, 04-11 RX8
Oil Level Sensor Seal, 04-11 RX8
SKU: 10-T110-N3H1 Manufacturer SKU: N3H1-10-T11 -
PILOT BEARING REMOVER TOOL
Pilot Bearing Remover Tool
To remove the old pilot bearing the bearing MUST be gripped at its front end. Very few of the aftermarket pullers we tested were able to do this correctly. They often tended to destroy the bearing making removal even harder.
To use the tool simply insert the attachment into the bearing, being sure to get it to the end of the bearing, insert the tapered / threaded end of the slap hammer part and screw them together until the bearing is firmly gripped. Then just “slap hammer” it out. Should take less than a minute.
This tool prevents eccentric shaft damage when removing bearing.
This tool does fit other cars including Miata. We do not have a list of cars that it will work on. The RX pilot bearing/input shaft measures .588″. If your application also has a .588 shaft/bearing, this tool will work.SKU: 49-1285 -
REAR MAIN OIL SEAL 04-11 RX8
Rear Main Oil Seal, 04-11 RX8
SKU: 10-5080-N3H1 Manufacturer SKU: N3H1-10-508 -
REAR MAIN OIL SEAL, ALL UP TO -95
Rear Main Oil Seal, All up to 95
SKU: 10-556A-1668 Manufacturer SKU: 1668-10-556A -
Water Seal Protector / Heatshield
Early Rotary Water Seal Protector
SKU: 23-0250-0866 Manufacturer SKU: 0866-23-025