SPARK PLUG SOCKET TOOL SPECIAL SMALL DIAMETER
Spark Plug Socket Tool, Special Small Diameter
Some (most?) of the “earlier” spark plugs, and some of the “not specifically for Mazda Rotary” racing plugs have a short body, as can be seen in the pictures. With the eyebrow on the rotor housings around the spark plug holes, from 1981 on, normal spark plug sockets are prevented from gripping the spark plug.
The “eyebrow” blocking the spark can be seen in the picture.
This socket is specifically made with a smaller diameter on the end so it can get between the spark plug and the housing.
The tool is fairly thin there so be careful with it — SPARK PLUGS ONLY!
There is NO warranty and no returns on this — We know what will happen – the same thing that happened around here way too many times. We go to use it, it is broken, and NOBODY touched it. The problem is it is the same size (13/16, 21mm) as lug nuts. Somebody tried to take a wheel off!!
Best advice is lock it up after YOU use it!!
| SKU: | 11529 |
SPARK PLUG SOCKET TOOL SPECIAL SMALL DIAMETER
(Ratchet in picture NOT included)
$165.00
Related Products:
-
FLYWHEEL STOPPER TOOL, ALL Non-Turbo diameter flywheels
Flywheel Stopper Tool, All Non-Turbo diameter flywheels (Except RX-8’s)
Flywheel stopper makes getting the flywheel / counterweight nut off a LOT easier.
For flywheels 11 3/4″ diameter.SKU: 49-220NT Manufacturer SKU: 49-220NT -
SPARK PLUG, BR8ET
NGK Spark Plug, BR8ET Both, Highway (cold)
For pionts ignition
NGK Stock # 6612SKU: BR8ET -
-
SOCKET ADAPTER TOOL, 1/2″ FEMALE TO 3/4″ MALE
Socket Adapter Tool, 1/2″ Female To 3/4″ Male
3/4″ adapter to use 1/2″ drive. The flywheel nut is put on with over 300 foot-pounds of torque and this adapter CAN BREAK! BE CAREFUL!! (sorry – there is no warranty on it). Better to get a hold of a 3/4″ breaker bar that has a warranty from somebody.
(Just to let you know kind of worst case – We have had a few where we needed to use our 1″, 1200 foot pound, impact gun with our 1″ drive impact 54mm socket!)
SKU: 49-22008 -
FLYWHEEL NUT WRENCH
Racing Beat Flywheel Nut Wrench
Having the correct tool always makes the job seem easy, right? Although you probably won’t be using this tool much, it will certainly pay for itself even if you only use it once! The Flywheel Nut Wrench tool is used to remove or install the 54mm (2.125″) flywheel retaining nut. During re-assembly, this tool will allow you to accurately re-torque the nut to the required 350 foot-pounds This tool can be used with the engine in or out of the chassis.
SKU: 22000 -
COMPRESSION TESTER, TWISTED ROTORS
Compression Tester Tool, for Rotary Engines
Browse our Rotary Tools SectionSKU: TR01
You May Also Like:
-
PORT TEMPLATE TOOL, RACE 12A EXHAUST
Exhaust 12A Race Port Template
Actual template not shown in photo.
SKU: 22211 -
-
-
-
-
DOWEL PIN REMOVER TOOL
Dowel Pin Remover Tool
Tool makes pulling the dowels out of the rotor and side housings a piece of cake during engine dis-assembly.
SKU: 49-1290