OIL HOSE RETAINING CLIP, SUPERSEDED USE N3G1-14-850A
This item has been superseded. Now use N3G1-14-850A
| SKU: | 14-6220-N3A1 |
| Manufacturer SKU: | N3A1-14-622 |
$0.00
Related Products:
-
OIL COOLER HOSE 93-95, AT COOLER SINGLE TYPE
Oil Cooler Hose, 93-95, At Cooler, Single Type
SKU: 14-830B-N3A1 Manufacturer SKU: N3A1-14-830B -
OIL COOLER HOSE SET, 04-08, RX8 AUTOMATIC OEM AT LEFT COOLER
Oil Cooler Hose Set, 04-08, RX8, Automatic, OEM, At Left Cooler
SKU: 14-830H-N3H1 Manufacturer SKU: N3H1-14-830H -
OIL COOLER HOSE SET, 04-08 RX8 STAINLESS
This set of fully assembled Stainless Steel Braided Hoses replaces the original factory oil cooler hoses on the 2004-2008 RX-8 Manual Transmission models (equipped with dual oil coolers). Costing much less than Mazda replacement units (over $1100 for the complete Mazda set!).
11911 Oil Hose Set-Installation Instructions
SKU: 11911 -
OIL COOLER HOSE 93-95, AT FRONT COVER TWIN COOLER
Oil Cooler Hose, 93-95, At Front Cover, Twin Coolers
SKU: 14-710E-N3A1 Manufacturer SKU: N3A1-14-710E -
-
OIL COOLER HOSE 93-95, AT COOLERS DUAL TYPE
Oil Cooler Hose, 93-95, At Coolers, Dual Type
SKU: 14-830B-N3A3 Manufacturer SKU: N3A3-14-830B
You May Also Like:
-
WEBER INLET SEAL, STAT-O-SEAL FOR 12MM
Weber Inlet Seal, Stat-O-Seal FOR 12mm
This is the seal needed for the -6AN fuel inlet fitting for Weber carbs.Click Here for a Weber 48IDA Suggested Parts List
Browse our Weber Carbs, Manifolds and Parts section
SKU: 357-12MM-STAT -
ADAPTER -10 18MM THREAD, 86+ COOLER & ALL REAR HOUSING
Adapter -10, 18mm Thread, 86+ Cooler & All Rear Housing
SKU: 11902 -
EXHAUST SLEEVE, TITANIUM 13B
Works great to replace non-turbo 13B sleeves and 20B sleeves.
Browse our 3 Rotor Engine Parts Catagory.
SKU: EXH-SLEEVE-TI -
WEBER SHAFT LEVER, WITH STOP PIN RIGHT
Weber Shaft Lever, With Stop Pin Right
This STOP is for when the carb fuel inlet is on the Engine side, cable pulling from ABOVE the shaft.
These are for what we call “Australian Style” manifolds.Browse our Weber Carbs, Manifolds and Parts section
SKU: MAT460-R -
WEBER STUD, 8X1.25 45MM
Weber Stud, 8X1.25 45mm
Most of the Weber Manifolds do not include studs to hold the carb to the manifold. These 45mm ones work great when you are using spacers — measure to be sure these are what you need – depends on the spacer thickness.Browse our Weber Carbs, Manifolds and Parts section
SKU: AV11983
Reviews
There are no reviews yet.