EXHAUST PIPE, U-BEND 3″ CENTER RADIUS
Exhaust Pipe, U-Bend 3″ Center Radius
| SKU: | 16189 |
EXHAUST PIPE, U-BEND 3″ CENTER RADIUS
U-Bend Pipe 2″ OD (3″ C/L Radius) – We offer U-bend tubes with either a 3-inch or 4-inch centerline bend radius for use in fabricating a custom exhaust system. The tubing used for this component is 2-inch O.D., mandrel bend mild steel with .120-inch wall thickness.
$37.60
Related Products:
-
-
-
-
-
EXHAUST O2 SENSOR WELD ON BUNG
Exhaust O2 Sensor Weld On Bung
Browse our Haltech Section
SKU: HT-010702
You May Also Like:
-
-
-
-
EXHAUST HEADER 13B, 74-78 NO FLANGE EXCEPT PICK UP
Racing Beat 13B Exhaust Header, 74-78 No Flange. Will not work on the Pick Up
This rotary exhaust Header/Collector (less outlet flange) is ideal for RX-2, RX-3, RX-4, and COSMO (does not fit rotary pickup) custom exhaust installations. The flame-cut, .5-inch thick engine flange provides positive sealing and alignment. By integrating the collector with the header we reduce the effort and cost in completing the exhaust system. Engine-to-pipe gaskets are not included but are available separately. An Air Control and Check Valve Cover Plate is required when using this header with a stock intake system.
If the stock resonator is eliminated during installation of this unit, we strongly recommend selecting a Power Pulse Presilencer and installing it in place of the resonator to maintain a pleasant noise level and character.
SKU: 16007 -
-
EXHAUST HEADER 13B, 79-92 4&6-PORT DUAL OUTLET
Racing Beat 13B Exhaust Header, 79-92 4&6-PORT DUAL OUTLET
SKU: 16127 Manufacturer SKU: 16127
