COMPRESSION TESTER, ROTARY COMPRESSION TESTER
Compression Tester Tool, for Rotary Engines
Browse our Rotary Tools Section
| SKU: | RCT-V5.2 |
COMPRESSION TESTER, ROTARY COMPRESSION TESTER
$285.00
You May Also Like:
-
SPARK PLUG SOCKET TOOL SPECIAL SMALL DIAMETER
Spark Plug Socket Tool, Special Small Diameter
Some (most?) of the “earlier” spark plugs, and some of the “not specifically for Mazda Rotary” racing plugs have a short body, as can be seen in the pictures. With the eyebrow on the rotor housings around the spark plug holes, from 1981 on, normal spark plug sockets are prevented from gripping the spark plug.
The “eyebrow” blocking the spark can be seen in the picture.
This socket is specifically made with a smaller diameter on the end so it can get between the spark plug and the housing.
The tool is fairly thin there so be careful with it — SPARK PLUGS ONLY!
There is NO warranty and no returns on this — We know what will happen – the same thing that happened around here way too many times. We go to use it, it is broken, and NOBODY touched it. The problem is it is the same size (13/16, 21mm) as lug nuts. Somebody tried to take a wheel off!!
Best advice is lock it up after YOU use it!!SKU: 11529 -
-
PORT TEMPLATE TOOL, 74-85 J-BRIDGE INTAKE 4-PORT
PORT TEMPLATE TOOL, J-BRIDGE INTAKE 4-PORT
The Racing Beat Intake Port Templates allow you to undertake your own “J-bridge” port efforts on any 12A or 13B rotary engine (except 13B 6-port). These templates are traced from Racing Beat’s own master templates, which are the result of years of research and development. The actual port shapes are traced on thin sheets of aluminum which you must first cut out, testing your ability to use a die grinder effectively before attempting to port an expensive engine component. The finished template is held in place and the porting shape is then traced onto each housing. You must then use your own judgment to develop the port shape beyond the scribed line.
SKU: 22200 -
FLYWHEEL STOPPER TOOL ALL N/A diameter flywheels
Flywheel Stopper Tool, All Non-Turbo diameter flywheels (Except RX-8’s)
Flywheel stopper makes getting the flywheel / counterweight nut off a LOT easier.
For flywheels 11 3/4″ diameter.SKU: 49-220NT Manufacturer SKU: 49-220NT -
PORT TEMPLATE TOOL, 86-99 TURBO HALF BRIDGE
Turbo Half Bridge Template 87-95 Turbo Engines (contains ports for center and end housings)
SKU: 49-222BT
