CLUTCH DISC RACE, 225MM 6-PUC TURBO SPLINE
Racing Beat Clutch Race Disc, 225mm 6-Puck Turbo Spline
“Special” Race (for use with 86-92 Turbo Transmission)
This special application 6-Puck, 225mm Race Clutch Disc– intended for use with the 1987-91 TURBO II gear box, with the larger diameter 23 tooth input shaft, mated to a 225mm flywheel–is designed for drag and road race use. The disc incorporates six (6) sintered copper pucks and a rigid hub for quick, positive engagement, greater fatigue resistance and improved heat dissipation. The sharpened engagement/disengagement characteristics of this disc require careful driver attention – this disc is not intended for street use.
As with all of our clutch products, it is built only from new parts.
Time Saving Tip: We strongly recommend replacing the throw-out bearing during any clutch work to ensure trouble free performance. Also, we recommend replacing the transmission front and rear seal kit when re-installing the transmission to reduce the possibility of leakage.
WARNING: None of the Flywheel or Clutch components shown in this catalog should ever be allowed to exceed 10,500 RPM under any condition. This same RPM limit applies to stock components. You must use an engine RPM-limiter to prevent excessive RPM. If your engine is capable of exceeding 8,500 RPM you must install a transmission scatter shield, or ballistic blanket. Failure to implement the above may result in serious injury or even death.
CLUTCH THROW OUT BEARING, S4 TURBO, S5 ALL, RX8 ALL
ClutchThrow Out Bearing, S4 Turbo, S5 All, RX8 All
SKU: 16-5100-F853 Manufacturer SKU: F853-16-510$42.90
Add to cart