RIVET PLASTIC, SCREW TYPE

You May Also Like:

• 

  CLUTCH HARDWARE FOR RACE 7.25″ RALLY TWIN

  Race Clutch Hardware for 7.25″ Rally Twin

  SKU:	298063RY-HW-725

  $14.36
  Add to cart
• 

  HYLOMAR TUBE, 1.5 OZ

  HYLOMAR TUBE, 1.5 OZ

  Best chemical we have found for water seal O-rings. Brush it on with a trimmed down “acid” brush – in the water seal grooves and then on the seals after you have placed them into the grooves. Stays tacky for a LONG time.

  One tube will do one engine easily.

  SKU:

  HYLOMAR

  $22.10
  Add to cart
• 

  WEBER INLET SEAL, STAT-O-SEAL FOR 12MM

  Weber Inlet Seal, Stat-O-Seal FOR 12mm
  This is the seal needed for the -6AN fuel inlet fitting for Weber carbs.

  Click Here for a Weber 48IDA Suggested Parts List

  Browse our Weber Carbs, Manifolds and Parts section

  SKU:	357-12MM-STAT

  $2.97
  Add to cart
• 

  WEBER SHAFT LEVER, WITH STOP PIN RIGHT

  Weber Shaft Lever, With Stop Pin Right
  This STOP is for when the carb fuel inlet is on the Engine side, cable pulling from ABOVE the shaft.
  These are for what we call “Australian Style” manifolds.

  All descriptions refer to a front mounted rotary engine in a rear wheel drive car.

  There are two types for downdraft IDA’s: fuel inlet on engine side with throttle cable pulling from above the throttle shaft, and fuel inlet on the fender side, with the throttle cable pulling from below the throttle shaft. The manifold determines the carb orientation. It is best to have the cable pull, the idle speed screw, throttle stop, and return spring all on the same end of the carb. If this is not done, you will twist the throttle shaft, which can lead to various poor running conditions.
  With this throttle STOP the throttle STOP is on the same side of the carb as the throttle PULL. Adjusted correctly this prevents the throttle shaft from being bent when full throttle is applied.
  And we all know the harder you push on the gas pedal the faster you will go ??

  Browse our Weber Carbs, Manifolds and Parts section

  SKU:

  MAT460-R

  $18.88
  Add to cart
• 

  CLUTCH RACE HARDWARE, FOR 5.5″ DOUBLE DISC

  Race Clutch Hardware, For 5.5″ Double Disc Race Clutches using our Race Flywheels

  SKU:	284063-HW-5.5

  $15.66
  Add to cart
• 

  -10 HOSE END, STRAIGHT

  -10 Hose End, Straight
  There are some custom applications where the available oil cooler line sets will just not work, and special length lines need to be assembled. We carry -10 ends in either straight, 45 degree, or 90 degree, as well as -10 hose.

  SKU:

  -10-END

  $14.66
  Add to cart